Design your own skateboard

Hot Topics:

By Phillip Torrone
Posted 2006/07/14 @ 5:50 pm
Category Art & Design, Energy

Boardpusher.com lets you design your own skate deck, here’s a MAKE version (feel free to use it!) – [via] – Link.

In the Maker Shed

Make Subscription

Makey Makey Standard Kit

Calculator Kit from Spikenzie Labs

Telegraph Decoder Kit by Spikenzie Labs

3 Responses to Design your own skateboard

bloggerdude on July 16th, 2006 at 5:22 pm said:

Are you a woodworker like me? If so Here are a few free tips: # while routing a piece of board with a router, route the end grain first, then with the grain to remove tearout caused by the first pass for a perfect job. # To remove dents from softwood such as pine dab with a touch of water wait a while for the wood fibers to expand and sand smooth. # While gluing end grain of wood coat the end with glue let dry a minute first to allow the end grain to absorb the glue. If you don’t do this the grain will absorb the glue after clamping staving the joint form glue causing a weak joint. Reapply more glue and clamp. # It’s best to apply a protective coating all areas of your woodprojects, including areas not seen, to prevent warping caused by one area absorbing moisture more than another. Check out my ebay store where I offer tool jig plans, free jigs and free tips. Keep checking back to see more added tips. Thanks for looking . Randy.
Please visit my ebay store by copying and pasting the following URL to your browser or search box http:/stores.ebay.ca/RANS-TOOL-JIG-PLANS-AND-STUFF

Reply ↓
bloggerdude on July 16th, 2006 at 5:25 pm said:

Are you a woodworker like me? If so Here are a few free tips: # while routing a piece of board with a router, route the end grain first, then with the grain to remove tearout caused by the first pass for a perfect job. # To remove dents from softwood such as pine dab with a touch of water wait a while for the wood fibers to expand and sand smooth. # While gluing end grain of wood coat the end with glue let dry a minute first to allow the end grain to absorb the glue. If you don’t do this the grain will absorb the glue after clamping staving the joint form glue causing a weak joint. Reapply more glue and clamp. # It’s best to apply a protective coating all areas of your woodprojects, including areas not seen, to prevent warping caused by one area absorbing moisture more than another. Check out my ebay store where I offer tool jig plans, free jigs and free tips. Keep checking back to see more added tips. Thanks for looking . Randy.
Please visit my ebay store by copying and pasting the following URL to your browser or search box http://stores.ebay.ca/RANS-TOOL-JIG-PLANS-AND-STUFF

Reply ↓
zac on January 24th, 2008 at 12:29 pm said:

i would like 2 make a scatebord 2 ride ,,|,,

Reply ↓