Comments on: Choosing Fasteners for Fused Filament Parts http://blog.makezine.com/2012/06/01/choosing-fasteners-for-fused-filament-parts/ DIY projects, how-tos, and inspiration from geeks, makers, and hackers Sun, 19 May 2013 08:29:13 +0000 hourly 1 http://wordpress.com/ By: Tool Review: Engineer PH-55 Scissors GT http://blog.makezine.com/2012/06/01/choosing-fasteners-for-fused-filament-parts/#comment-750096 Wed, 17 Oct 2012 14:55:55 +0000 http://blog.makezine.com/?p=218613#comment-750096 [...] Choosing Fasteners for Fused Filament Parts [...]

]]> By: MAKE | Tool Review: Engineer PH-55 Scissors GT http://blog.makezine.com/2012/06/01/choosing-fasteners-for-fused-filament-parts/#comment-749764 Wed, 17 Oct 2012 05:46:33 +0000 http://blog.makezine.com/?p=218613#comment-749764 [...] Choosing Fasteners for Fused Filament Parts [...]

]]> By: Choosing Fasteners for 3D Printed Parts – Part 4 http://blog.makezine.com/2012/06/01/choosing-fasteners-for-fused-filament-parts/#comment-591122 Wed, 13 Jun 2012 20:09:50 +0000 http://blog.makezine.com/?p=218613#comment-591122 [...] Earlier this month, we linked out to the first three posts in the I Heart Robotics team’s ongoing series about choosing hardware for the fused-filament parts that come off your RepRap-type 3D printer. On Sunday, they published the fourth installment, this time focusing on the best way to make a rotating pin joint between two printed beams, for instance in the “knee” of a robot leg. They experiment with various configurations of pop rivets, tubular rivets, flat washers, spring washers, clevis pins, and E-rings. Click through, below, to check out their results. [...]

]]> By: MAKE | Choosing Fasteners for 3D Printed Parts – Part 4 http://blog.makezine.com/2012/06/01/choosing-fasteners-for-fused-filament-parts/#comment-590661 Wed, 13 Jun 2012 16:11:20 +0000 http://blog.makezine.com/?p=218613#comment-590661 [...] Earlier this month, we linked out to the first three posts in the I Heart Robotics team’s ongoing series about choosing hardware for the fused-filament parts that come off your RepRap-type 3D printer. On Sunday, they published the fourth installment, this time focusing on the best way to make a rotating pin joint between two printed beams, for instance in the “knee” of a robot leg. They experiment with various configurations of pop rivets, tubular rivets, flat washers, spring washers, clevis pins, and E-rings. Click through, below, to check out their results. [...]

]]>