RSS
In the Build your Own Arcade Controls Message forums there are tons of great ideas suggestions and how-tos- here's on on flush mounting a Trackball. Frosty says "Basically, I set my router depth to match the depth of the top of the mounting plate (about 1/8" of an inch), and routed the outline of the plate. When dropped into the recess, it sat flush with the top of the CP. The artwork was placed on the panel and mounting plate (covering it) and then Lexan on top of it". Link.
Flush Mounting a Trackball
Posted by Phillip Torrone |
May 13, 2005 08:35 AM
Gaming |
Permalink
| Comments (0)
| Email This |
| Digg this!
Recent Entries
- 3D renderings of the Mandelbrot set
- New in the Maker Shed: Microbe Motel kit
- Science through graphic novels
- Tiny solar-powered brass engine in a wineglass
- Maker Shed kiosks at Fry's
- New hackerspace in Chicagoland: Workshop 88
- Mint tin electronics dev kit packs the essentials
- Olympus BioScapes competition winners
- Mac mailbox
- LHC tweets its first circulating beam of 2009
Leave a comment
Subscribe to MAKE Magazine!
Subscribe today, save 42% and get web access to MAKE free. MAKE Digital Edition is available only to subscribers.
$34.95 / 1 year
(4 Quarterly Issues)
