RSS
Procure IR modules from an old VCR, Raphael writes "Some time ago, I came across the Lirc (Linux Infrared Remote Control) website and decided to build a serial port IR receiver. They had a list of suggested IR receiver modules, but I was unable to buy one, so I had to think of using something else. A IR Receiver module is usually a photodiode and a 38khz detector. Most of them have 3 pins. VCC, GND, an output pin. If a 38khz carrier is detected, the output pin will become active. Some modules are active low, and others are active high. It is sometimes required to use an inverter(eg: 7404) to get the correct signal." Link.
HOW TO - Using IR modules from VCRs
Posted by Phillip Torrone |
Jan 1, 2006 02:52 PM
DIY Projects, Electronics, Home Entertainment |
Permalink
| Comments (0)
| Email This |
| Digg this!
Recent Entries
- Stained glass d20s
- CRAFT Thanksgiving roundup
- 3D renderings of the Mandelbrot set
- New in the Maker Shed: Microbe Motel kit
- Science through graphic novels
- Tiny solar-powered brass engine in a wineglass
- Maker Shed kiosks at Fry's
- New hackerspace in Chicagoland: Workshop 88
- Mint tin electronics dev kit packs the essentials
- Olympus BioScapes competition winners
Leave a comment
Subscribe to MAKE Magazine!
Subscribe today, save 42% and get web access to MAKE free. MAKE Digital Edition is available only to subscribers.
$34.95 / 1 year
(4 Quarterly Issues)
