David writes in -
NAND flash chips are used in all sorts of electronics for storing information/firmware etc. If you are interested in trying to get the information out to study, then I may have something useful for you. This is how I read the flash chip without removing it from the device.
Posted by Phillip Torrone |
May 7, 2007 06:00 AM
DIY Projects, Electronics |
Permalink
| Comments (2)
| Email This |
| Digg this!
Oldest comments listed first.
Subscribe to MAKE Magazine!
Subscribe today, save 42% and get web access to MAKE free. MAKE Digital Edition is available only to subscribers.
$34.95 / 1 year
(4 Quarterly Issues)
Check out all of the episodes of Make: television
 |
MAKE on Facebook Visit our Facebook page and become a fan of MAKE! |
 |
MAKE on Twitter Follow our MAKE tweets! |
 |
MAKE on Flickr Join our MAKE Flickr Pool! |
Why advertise on MAKE?
Read what folks are saying about us!
Click here to advertise on MAKE!
Gareth Branwyn
Senior Editor
Phillip Torrone
Senior Editor
| AIM | Twitter
Becky Stern
Associate Editor
| AIM | Twitter
Marc de Vinck
Contributing Writer
| AIM | Twitter
John Park
Contributing Writer
| Twitter
Sean Ragan
Contributing Writer
| Twitter
Matt Mets
Contributing Writer
| AIM | Twitter
Dale Dougherty
Editor & Publisher
| Twitter
Shawn Connally
Managing Editor
| Twitter
Goli Mohammadi
Associate Managing Editor
Kip Kay
Weekend Projects
| AIM | Twitter
Collin Cunningham
Contributing Writer
| AIM | Twitter
Adam Flaherty
Contributing Writer
| AIM | Twitter
More contributors: Mark Frauenfelder (Editor-in-Chief, MAKE magazine), Kipp Bradford (Technical Consultant/Writer), Chris Connors (Education), Diana Eng (Guest Author), Peter Horvath (Intern), Brian Jepson (O'Reilly Media), Robert Bruce Thompson (Science Room)
Weekend Project: Beetlebot
Simple robot from your parts bin that avoids obstacles. Thanks go to Jerome Demers for the original article in MAKE, Volume 12. To download the Beetlebot video, click here or subscribe in iTunes. Check out the complete Beetlebot article...
More...
www.flickr.com
|
www.flickr.com
|
Help | Write for MAKE | Contact Us | Subscribe | Advertise with Us | Privacy Policy| About MAKE | FAQ
© 2009 O'Reilly Media, Inc.
All trademarks and registered trademarks appearing on makezine.com are the property of their respective owners.
RSS
This is a great looking hack. The jig will be really fragile, though. We've used the Tektronix probes made just for this purpose: they were very expensive, NOT easy to use and NOT reusable, either.
One thing that might help is mixing standard solder with just a little bit of ChipQuick to lower the melting point. This adds problems since the mix is bad for wetting and reduces the strength of the joint. It does make the operating temperature lower which is good to keep from damaging the part & board & jig. Only using a little bit of ChipQuick gives you some of the best of both worlds.
Also, emphasize the use of liquid flux & plenty of 91% isopropyl alcohol for cleaning, and to watch for the jig to dry off after you clean it. Also, to watch & make sure that cleaning alcohol doesn't sneak under any nearby BGAs where it will take forever to dry out.
Reply to this comment
@ solderer
Great points! One thing you can do to make it a little sturdier is to use a little hot glue under the wedge boards for some support. Not the perfect solution, but it can be removed without too much difficulty providing you pay attention to where you glue ( not on multiple pin parts, for example).
Reply to this comment