Make:

Greg's "cameleon lamp", he writes -

Concept: To design a light that mimics a color if shown to it. Design: lamp driver. LEDs are very efficient as they only emit one frequency of light, and because of this the light produced could be perceived as flat and lifeless. Instead i used tungsten bulbs because unlike LEDs they aren’t flat and lifeless. Because the Arduino cannot provide enough current to power a tungsten bulb without damaging the Arduino chip, I had to use transistors to turn a separate power source on to power the bulbs. This also meant that the lamp wouldn’t draw too much current from the laptop. To do this i connected the pwm pins to base of the transistors, and grounded the transistors to the Arduino’s ground in series with diodes to prevent current flowing back through the tungsten bulbs from the Arduino. Because i used the pwm pins i could dim the bulbs the same way one can dim LEDs in the Arduino code.colour sensor. Because I wanted the lamp to detect colors and mimic them, I prototyped a simple color sensor.