RSSSpray can lighting
Posted by Gareth Branwyn |
Jul 17, 2009 12:00 PM
Furniture, Green, Remake |
Permalink
| Comments (5)
| Email This |
| Digg this!
Recent Entries
- Stained glass d20s
- CRAFT Thanksgiving roundup
- 3D renderings of the Mandelbrot set
- New in the Maker Shed: Microbe Motel kit
- Science through graphic novels
- Tiny solar-powered brass engine in a wineglass
- Maker Shed kiosks at Fry's
- New hackerspace in Chicagoland: Workshop 88
- Mint tin electronics dev kit packs the essentials
- Olympus BioScapes competition winners
Comments
Oldest comments listed first.
Leave a comment
Subscribe to MAKE Magazine!
Subscribe today, save 42% and get web access to MAKE free. MAKE Digital Edition is available only to subscribers.
$34.95 / 1 year
(4 Quarterly Issues)
Gareth - Thanks for the link to DudeCraft! Those cans are cool, aren't they? Cheers.
Reply to this comment
Love the site, Paul. Visit it all the time.
Reply to this comment
I love this idea. I have a concern about removing the bottoms from the cans, even after depressurization. Any advice or experience?
Reply to this comment
I don't see any instructions for bleeding the pressure off these cans. Are you certain that depressing the spray can nozzle button will exhaust all the pressure? I have always heard that cutting into pressurized cans can be dangerous.
Reply to this comment
I think the impression that they're explosively dangerous is slightly overblown. If you spray the nozzle until the can is empty and then put the can inside something to protect yourself from any shrapnel, and then puncture the can with a nail, you should be fine. A guy on Flickr wanted to see what would happen if he punctured a can. He built a wooden box just bigger than the can, with a hole at the bottom-side for a nail. He punctured it and there wasn't much pressure release. I think if you guard against anything being able to flying at you, wear goggles, make sure the can is as empty as possible, etc., you should be fine.
Reply to this comment