Carving stamps from erasers

Hot Topics:

By nataliezdrieu
Posted November 13th, 2006
Category Uncategorized

Lil sent us this link with tons of tips for carving stamps from erasers. Pictured here is a eraser carved stamp by Litsa Spathi from Heidelberg , Germany. Link.

Related:
More on rubber stamp from erasers – Link.

In the Maker Shed

Getting Started with Raspberry Pi

BeagleBoard BeagleBone Black

Tux Case for Raspberry Pi

Brooklyn Aerodrome Flying Wing Kit

3 Responses to Carving stamps from erasers

GeoBrett on November 14th, 2006 at 4:01 am said:

Another easy way to get design onto stamp in reverse is to use tracing paper and 4B or softer lead in mechanical pencil.
First, Draw you design that will fit on the block you’ll be using.
Second, Trace it using a soft lead (4B, 6B) pencil or mechanical pencil.
Third, Place lead side down onto block and then gently rub (burnish) the back of the tracing paper making sure not to move it. You can use smooth surface like small spoon or rounded end of a pen. If you move or wiggle the paper the design will smudge and be hard to capture details.
Fourth, If you plan to take a while cutting (not all in one go) you can then use a permanent fine line marker to retrace the design on the block.
Note: I like using the Speedball Linoleum Cutters with the white carving blocks / erasers
Once upon a time I was cutting 5 or 6 stamps a week. Some examples can be seen on my OR Post pages and some mORe

Reply ↓
jima@legnog.com on November 14th, 2006 at 7:37 am said:

See also these groups on Flickr: Carve your stamps; and Stamp Your Art Out. One group member put together a Flickr tutorial on carving stamps.

Reply ↓
Germany Handcrafted Jewelry on November 23rd, 2006 at 3:00 pm said:

Germany Handcrafted Jewelry

Reply ↓