Make: Projects
Electronics Parts Storage
I needed a better way to store and find resistors, diodes etc. I had a drawer that was too shallow to use for most things but found it perfect for this project.
Steps
Step #1:
- I used 3/4" MDF for this and routed out the cavities for the parts with a 1/2" round bit on a router table. The slots are every 1 inch on center and about 5/16" deep. That leaves 1/2" between the slots to put the labels for the contents of the slot. The slots are about 3" long to accommodate 1/4 watt resistors and diodes.
